Those who have as1 or ft1 skates...

[Sniper9 517]

Is the inside sole (when you remove the footbeds) not flat? As in bumpy around certain areas especially where the rivets are (indented). When I run my hand on the bottom into the forefoot, it isn't flat and feels "lumpy". Not sure if it's from the heat moulding or if it's just like this but I vaguely remember it was possibly like this out of the box.. I've attached pics but it's a bit hard to see.. it's more apparent on the right skate.  I don't notice it when the footbeds are in.  Just wanted to know if I messed it up during the heat moulding. 

I'm not talking about the texture of the actual material, but actual indents where the rivets are and throughout the sole that feels almost like domes. 

 

Edited February 15, 2019 by Sniper9

[Vet88 673]

My AS1's are the same, the rivet pulls the sole down and the spaces in between are at the original height.

[tcraig 42]

My original SuperTacks are the same way.