Jump to content
Slate Blackcurrant Watermelon Strawberry Orange Banana Apple Emerald Chocolate Marble
Slate Blackcurrant Watermelon Strawberry Orange Banana Apple Emerald Chocolate Marble

Cyberoller

Members
  • Content Count

    5
  • Joined

  • Last visited

  • Feedback

    N/A

Community Reputation

0 Neutral

Profile Information

  • Spambot control
    123456789
  1. Thanks for the replies, I did think it was odd that the holes were different but rechecking the rear copper holes on the skates (CCM as1) don't seem to be big enough for a 5/32" drill bit, they seem to be 9/64". I guess I could solve my own problem by just using steels 😉
  2. Many thanks for the reply 5/32 is about what I'd guessed for steels, but the original CCM coppers I removed seemed a bit smaller, is there a standard drill size for them?
  3. I'm changing over holders but the holes will need redrilling. I want to make sure that the holder alignment is exactly how I want rather than a shop just fitting around the existing holes as I've seen happen. Could someone enlighten me as to the correct diameter hole for steel rivets and coppers. Thanks
  4. If you could measure that would be great! A picture of the overhang would be great too! Do you play competitive in line on the R1's and how do you find them. Thanks
  5. I'm looking at putting a set of R1 Mars blades on a pair of 8.5 EE CCM AS1, the Mars blades sizing chart suggests 8.5 is the last size that a medium chassis fits on. Would a large chassis fit?? Or will it massively over hang? The reason I ask is we had a set of medium 01's which were mounted on some 7.5 EE's (again the largest boot size) and they felt undersized. Thanks
×
×
  • Create New...