Drill size for holder rivets.

[Drill size for holder rivets.]

Thanks for the replies, I did think it was odd that the holes were different but rechecking the rear copper holes on the skates (CCM as1) don't seem to be big enough for a 5/32" drill bit, they seem to be 9/64".

I guess I could solve my own problem by just using steels 😉

[Drill size for holder rivets.]

Many thanks for the reply 5/32 is about what I'd guessed for steels, but the original CCM coppers I removed seemed a bit smaller, is there a standard drill size for them? 

[Drill size for holder rivets.]

I'm changing over holders but the holes will need redrilling. I want to make sure that the holder alignment is exactly how I want rather than a shop just fitting around the existing holes as I've seen happen. Could someone enlighten me as to the correct diameter hole for steel rivets and coppers. 

Thanks

[Ask me anything about the Marsblade R1]

If you could measure that would be great! A picture of the overhang would be great too! 

 

Do you play competitive in line on the R1's and how do you find them. 

Thanks

[Ask me anything about the Marsblade R1]

I'm looking at putting a set of R1 Mars blades on a pair of 8.5 EE CCM AS1, the Mars blades sizing chart suggests 8.5 is the last size that a medium chassis fits on. Would a large chassis fit??  Or will it massively over hang? 

The reason I ask is we had a set of medium 01's which were mounted on some 7.5 EE's (again the largest boot size) and they felt undersized. 

Thanks