Blackstone Flat-Bottom V Thread

[Blackstone Flat-Bottom V Thread]

Guy's,

when you cut a blade edge on an angle it's weak! The edge won't hold up! You would never support a bridge with an angle support. You would support it with an arch. It's PHYSICS. NOT MAKE BELIEVE..

[Blackstone Flat-Bottom V Thread]

Not too impressed with how the X01 came from the factory.

The pitch was WAY off, the blade was visibly pointing upwards just to contact the wheel. Don't they check this for each machine before it leaves Blackstone? had to turn pitch like 20 turns just to get the skate level to the wheel.

The spinner was installed upside down with the c-clip up. Spring clip way too tight so the spinner wouldn't spin. One of the Steve's at Blackstone was very helpful in troubleshooting.

I'm still undecided on how good the X01 is. Tabletop is not too slick.

Didn't have this much trouble getting a Wissota working out of the box.

Blackstone has nothing made in there own factory. Everything is outsourced. They have no quality control manager.