spartansniper 0 Report post Posted May 30, 2004 i have an inno 1100 fused and i was wondering where to cut the blade off to put in a synthesis blade? will a synth blade fit? thanx in advance Share this post Link to post Share on other sites
Eazy_b97 1 Report post Posted May 30, 2004 I tapped a metal object to see where it was hollow and cut there. It lost a bit of the taper, but I didn't notice. It fit a Synthesis blade nicely. Share this post Link to post Share on other sites
CaptainZbubble 0 Report post Posted May 30, 2004 i cut just above the innovative symbol on the bottom of the shaft. i Cut right on the top of the circle and it worked very nice.CaptainZbubble Share this post Link to post Share on other sites
