Cutting an int bauer endure ops

[snap 0]

I Just broke my endure and dont know where to cut it.... or if it will take a

standard or a taperd blade.

[zinNergy 0]

Start low and work your way up, most likely tapered if you cut with patience. If there is a noticeable fuse point (a bump or irregularity where the blade connects to the shaft) then work your way up from there.

Also make sure you use advance search because im sure I've seen quite a few "where to cut" threads try "cutting an Easton stealth" for a good imformative thread.

[snap 0]

Thanks but my stick broke right where the it says 0.470 composite is that to far up for a tapered blade. Sorry should have put this in the first post.