Jump to content
Slate Blackcurrant Watermelon Strawberry Orange Banana Apple Emerald Chocolate Marble
Slate Blackcurrant Watermelon Strawberry Orange Banana Apple Emerald Chocolate Marble

Archived

This topic is now archived and is closed to further replies.

irbenaid

One 95 Runner Change?

Recommended Posts

Ok, probably a dumb question.... I used a socket wrench 5/16" to take off the little bolt that kind of looks like what would go on the air valve of a tire. What else do I need to do to get the runner off?

Share this post


Link to post
Share on other sites

Nothing. The front is a hook. Slide the blade forward while pulling it away from the skate downward (think 45* angle). Pull from the middle or front of the steel, don't simply pull the back of the steel down. It slides in and out. If it's stuck grab the boot by the tendon guard (NOT the guard though) and give the steel a good whack on a rubber mat by swinging the boot. Use caution of course.

Share this post


Link to post
Share on other sites

hold the boot upside down...this way the nut doesn't fall into the hole. It also helps that your wrench is magnetized so it clings onto the nut. It takes a bit of fiddling around to get the nut to line up though, but i've found that this way works the best

Share this post


Link to post
Share on other sites

×
×
  • Create New...