deljaso

Thanks, I got in there and removed the set screw (mine had only one in there) and lowered the wheel. I appreciate your help! Then I go to recalibrate the holder and sure enough, I lost my calibration block, hahahhaha. I guess I'll do it by trial and error. And I have to give a big thumbs up to Blackstone's customer support. I posted this here because I thought I'd get a quicker response (and if someone else needed the information they could see the solution), but they gave me the same information you did, and very quickly!! Before I bought my sharpener and since, I have read many pages of this thread. i am reading more and see that it has been posted a couple of times.

For those of you that have an X01 sharpener, can you do me a favor and look at where the spinner contacts the grinding wheel? My spinner has always contacted the wheel high - I am attaching a couple of pictures from my sharpener that show the height of the wheel where it contacts the spinner, and the wear pattern on my spinners. I had a heck of a time getting even edges on a new pair of my kid's skates and looked at it closer and I'm wondering if there is a height adjustment somewhere that I'm not seeing on either the wheel or the spinner. The worry here is when I'm using the FBV spinner, that I'm actually getting the flat/fangs correctly cut into the grinding wheel. You can see from the pictures that the bottom 1/4-1/3 of the spinner is not used.