Graf RMS Holes

[stunner 0]

Hey guys/gals, i recently took the holders off my skates and i noticed that one of the RMS holes seems to be getting bigger/wider. it is on my right boot; the last one on the inside heel. has this happened to anyone else? i am kind of worried because the hole is getting pretty close to the edge of the outsole. i was wondering if it would be ok to leave or if i should go get them fixed. if i were to get them fixed should i have them fill in the hole and drill in the same spot, or should i get them to drill a new hole? also would this be eligible for warranty? here are some pics:

-thanks the the help.

[JR Boucicaut 3810]

Just pull it out and put in a copper rivet or two. Since Graf only uses 4 holes per tower, you have plenty of room.

[slinky 0]

I had a previous post and didn't get any response. I am looking for a replacement set of screws for a buddy who stationed overseas in the military and has no access to a shop thanks.

[GREGROYA 0]

There used to be a company called Gorilla nuts out there that had a wider base and were very easy to use I don't know if they still exist or not.

[JR Boucicaut 3810]

I had a previous post and didn't get any response. I am looking for a replacement set of screws for a buddy who stationed overseas in the military and has no access to a shop thanks.

What do you need, anchors or screws?

[slinky 0]

He is looking for both,a few are rusted and the rest are starting to strip. Any help would be greatly app.Thanks.

[JR Boucicaut 3810]

Let me know what he is looking for. I have new screws and a ton of used anchors but still good. Both short (front) and long (rear)