Pitch 3 blade adjustments

[Hockeydog 8]

I have a pair of Mission AGX skates which are awesome. However when trying to adjust the pich settings I run into problems. I should be able to loosen the front screw and then take the back piece off and adjust the angle but in order to get the back piece in I have to take the front piece completely off, which then is hard as hell to get back on. Any tricks to this? I am not planning on doing this much but after getting a profile I bumped it up to +1 and am thinking about dropping it back to neutral but don't want to wear out the hardware any more. Thanks!

[K9 Unit 1]

ye i had that problem with my mission when i changed it to +1...i ended up filing both the blade's hole and the holders hole until i could painfully shove the screws back in...for some reason it was only on one boot for me though

[cris8 0]

You don't need to take off the front - just the back. The front only needs to be loosened. See more info on this thread.

Pitch3

[Hockeydog 8]

Thanks for the posts and the link. I did try just unscrewing the back , but I'll try using Chadd's method.