CCM resistance + bauer concept 3

[hockeyshield 2]

10 minutes ago, Dizzyg12 said:

Nope!  I use the Oakley spray and it’s fantastic.  

Thanks.

[ClearlyCoach 0]

On 9/24/2016 at 3:49 PM, Dizzyg12 said:

Short story before my trick/tip.

So, I wanted to try the concept 3 and I didn't like how it fit on my ims 7.0 so I went on a helmet search.  I tried the reakt 100 & 75.  The 100 sat too high and the 75 had too much gap on the sides even closed tightly to the point my forehead hurt.  

I found the resistance and the resistance 300 to be a better fit.  Deeper and closer fit without being too tight.  The problem was the concept 3.  The clips as we all know don't work since the holes are wider. At first  I was able to angle the screws and get the shield on but it warped the front of the helmet causing it to flatten out and then Be too tight on my forehead. 

Sooooo, we mod!  That's what we do!

took a razor knife to the clips and shaped them to be an "L" which allows them to spread wider and over the edge of the bar at the top of the helmet.  See pics.  10 minute fix.  

Its technically the "wrong" way to mount it but I like it better this way as the "seam" of the cage/shield is lower and less obstructive.  I play tonight so we'll see how it goes.

9 years later and this is still a helpful post. Thank you for this.