mission & factory Z

[Chadd 916]

Call Me and I will take care of this for you...

401-946-4400 ext 3050

I apoligize if I was the one who dropped the ball on this...

Mike

You may want to send info like this via a private message.

[MDE3 0]

Product suggestion:

This hub issue happens with a fair amount of regularity with many of the manufacturers. I have seen it in at least three that I recall, but in multiple models and at different times......

Someone should make a scraper tool that is the exact diameter of the bearings, and with a cutting surface that engages the hub of the wheel but with a flange that prevents the cutter from going too deep. The outside of the wheel hubs are almost always exactly 1.000" wide, so the tool would have a flange with exactly .301" of tool below the flange. This would assure a hub width that does not exceed .398"... solving the problem.

One or two rotations of this tool inside a wheel on each side, could correct these minor deficiencies...and save everyone a lot of time and money..... B) (I get 25%)

....anyone care for a "Guiness"?........ :P

[RINK RAT 15 0]

No private message needed...I'm available to talk with anyone on these boards...

In good times and in bad!!!!!

Mike

[Benchboy 0]

Hey Mike

I sent you a PM a couple of days ago. Did you get it?

[Benchboy 0]

Hey Mike.

I still can't seem to get you thru PM.

Can you please email me at cwal1151@bigpond.net.au

Thanks.

Matt.

[MDE3 0]

Try reaching him at mhunt@mearthane.com, or calling RR directly at 1 410 946 4000, ext. 3050, if you are seriously in need........

[Benchboy 0]

Cheers.