I bought an already cut down Synergy SL from ebay. I would think it was cut an inch or so high based on the posts in this thread, but my CCM V130 blade slides in rather snugly. I moved it around before the glue cooled and noticed a tiny bit of front to back movement (mostely due to the taper in the shaft not contacting the part of the blade hosel that is inside, like in an untapered shaft). Has anyone else noticed this? I pulled it before it cooled thinking it was too loose...would adding a layer of tape tighten this up? Also, the tape should be at the bottom of the tenon that goes into the shaft as opposed to the top...right?