holders

[crussell1488 0]

I was thinking about putting either tuuk custom + holders or lightspeeds on my synergy 1300c's. Anyone experienced any difficulties besides drilling new holes? Is there really even that much difference between the razr bladz IIs and the tuuks?

[DeI 18 0]

This should probably go in the Ice Hockey Equipment forum.

Also, I'm sure that a few people on the board have done this, so try searching around a bit.

[JR Boucicaut 3815]

RBII and Tuuk + are exact - LS are not - I've done a couple of swaps and you have to basically expand the holes.

[Keith 0]

Try getting your hands on some non-parabolic steel. Those easton holders are really not bad at all.

[JR Boucicaut 3815]

Agreed...I got a pair of solid steel and it was pretty good.

[Fonya 0]

Yea, the only problem is that the steel breaks in half all the time. Holder isnt bad at all.

[crussell1488 0]

Do lightspeed II steel fit on the easton synergy holders?

[troybruins89 0]

No, LS2 steel only fits on the LS and LS2 holders.

[crussell1488 0]

which steel other than the parabolic crap fits on the RBII?

[Keith 0]

Easton makes steel for that holder that is not parabolic.