wickedwrister 0 Report post Posted February 1, 2006 Is there any way that would last to trim the toe on a composite blade? I have an extra Synthesis blade that is longer than retail by about 1.25". I can't think of any, but....... Share this post Link to post Share on other sites
#44wannabe 4 Report post Posted February 1, 2006 a hack saw then some sort of hard filler glue type thingy ;) Share this post Link to post Share on other sites
Squirrel 0 Report post Posted February 1, 2006 a hack saw then some sort of hard filler glue type thingy ;) Epoxy? Share this post Link to post Share on other sites
ash_96 0 Report post Posted February 1, 2006 the toe split on my xn10 so i put some epoxy type stuff in it, ruined the feel of the blade. so be prepared that this could happen if you go that route with your blade! Share this post Link to post Share on other sites
Project_2501 0 Report post Posted February 1, 2006 Try to get some carbon epoxy or maybe some fiberglass epoxy. Share this post Link to post Share on other sites
notorious#29 0 Report post Posted February 1, 2006 Is there any way that would last to trim the toe on a composite blade? I have an extra Synthesis blade that is longer than retail by about 1.25". I can't think of any, but....... I cut about 3/4 of an inch off the toe of one of my Modo Z-carbons last summer. Then I epoxied the toe and put some tape over it. Worked fine, I diddn't notice any difference in feel or anything. So you should be ok. Share this post Link to post Share on other sites
ChrisGass9909 0 Report post Posted February 2, 2006 dont mean to interrupt but wicked have you shipped my apollo yet Share this post Link to post Share on other sites
Project_2501 0 Report post Posted February 2, 2006 Shouldn't that be included in a PM? Share this post Link to post Share on other sites
ChrisGass9909 0 Report post Posted February 2, 2006 i pmed him like 5 times and he still hasnt responded Share this post Link to post Share on other sites
