Cutting stealth CNT blade part II

[sfael 0]

So i never got a definitive answer , for the stealth CNT can you put a blade in it? tapered or standard? and where do you cut it?

Thank you

[Chadd 916]

Yes you can cut it.

Where you cut it will dictate if it will be tapered or standard.

It's no different than cutting a XXX, True1, Mac Daddy, etc...

http://www.modsquadhockey.com/index.php?ac...ighlite=cutting

[sfael 0]

ok thanks a bunch chadd for your direct response.

[sfael 0]

one more question is the stealth CNT a true one piece or is it fused? if it is one piece i line a tapered blade to it and cut where the blade would end? if it is fused i cut on the fuse point? but i dont think my stealthCNT has a fuse point am i correct?

[Chadd 916]

There is no fuse point on the shaft. Cut low and work your way up the shaft until a tapered blade fits.

[malcb33 100]

Well I believe that stealths have a different type of fuse point! To answer your question though, it doesn't have a tennon inside the lower part of the shaft (so it is hollow all the way down). You should be able to line up a tapered blade, and maybe try cutting a little lower just incase??

[sfael 0]

so i should just line up a tapered blade against the blade in the stick and cut where the tapered blade part where it is supposed to show ends?

[lesterhenson 0]

Just cut it low and keep going up until the blade fits. The procedure could not be any more straight forward.