Hosel Lenght?

[Patrick67 1]

Currently I have a shaft with a Bauer Endure P91 (Kovalchuk) in it.

The blade is getting shot, and I was thinking about replaceing it with a AK27 Kovalev RB.

Know there is a lie difference (Bauer lie is a little too high, so that's fine) but what about a difference in hosel lenght?

Bauer makes (IMO) long hosels, does anybody know how much shorter the Warrior hosel will be?

I play with tackimac grips, so would rather avoid tempering with the shaft lenght. Thanks in advance! :)

[chippa13 1844]

From what I've seen of Warrior blades, their hosels tend to be longer than most, not shorter. At least for the tapered blades.

[hergs 7]

AK 27 is for standard shafts

Dolomite is for tapered shafts, and yes the warriors are a bit longer

[DamnLocust 0]

I was under the impression that ak's and older standard innos actually had a shorter hosel than most standards. I thought I read that the hosel is actually the same length as inno's/ warrior's tapered blades.

[mreeves 0]

ccm and dolomite tapered are the same length hosel. the endure should be right in there.

[Jake 0]

I know that my Dolomite hosels are 1/2 inch longer than my Synthesis blades.

[narwhal 0]

My Dolomite's hosel is about an inch longer than a TPS R2.

[Patrick67 1]

DammLocust: If it's true that the Inno/Warrior taper and standard blades are the same hosel lenght then Bauer most be a little longer than Warrior, because my Inno Tapered Mogilny blade is a inch shorter than the Endure blade.

I'll make the switch, thanks for all the reply's.