Holder size question

[ajaxmt10 0]

I would like to put some mission pitch holders on my Graf 705's. My Graf's are size 7.5. My question is what size mission skate would have the same size holder? Since the fit of the mission skates is different then most skates im not sure what size to get. I need the size of the skate because its cheaper to get a pair of s200-s300 or L3-L4 then it is to get the holders.

[DamnLocust 0]

Mission skate sizing are actually closer to other manufacturers nowadays.

My friend has a pair of L7s and a pair of Graf 703s, both size 8.5.

[JR Boucicaut 3805]

You match holder sizes. On the Cobra the size will be on the rear tower, inside edge.

[ajaxmt10 0]

I need 263 holders but what size boot do they come on from mission?

[JR Boucicaut 3805]

8.

The only downfall to that is that those skates (well at least the S series) might have the round bolt system. That steel to fit that holder can't be found anymore. You have to ask them if the bolts on the inside edge are square.

[ajaxmt10 0]

Does the s400 in size 7.5d use a 263 holder?

When did they change to the square bolt? So would it be cheaper to just get holders since most of the skate on ebay will come with the round bolts?

[Chadd 916]

Does the s400 in size 7.5d use a 263 holder?

When did they change to the square bolt? So would it be cheaper to just get holders since most of the skate on ebay will come with the round bolts?

04 was round bolt, 05 to present is square.

[JR Boucicaut 3805]

Thank me for that one :)