rivet patterns of different holders

[dix0r 0]

ie, the holes on a pitch3 line up with the holes on a razor bladz II holder - what other holders can be swapped out for each-other without needing to drill?

[kovalchuk71 212]

Pitch and Custom+

[deadmanjolt 1]

hearsay says Cobra nt 3000 and Custom+ and by extension Pitch.

[dix0r 0]

about the cobra NT3000 / custom +

i saw some pro stock grafs up close the other day (norstrom's and avery's, i believe) and they had custom + holders mounted on them. they used the RMS screws, but they weren't using all of the holes on the holder (it was either 6 or 8 out of 10 were used). made me wonder if that many holes lined up, since they kept the screws rather than using rivets.

i actually had to re-mount a custom + on a customers 707 skate yesterday and i forgot to check. can anyone say definitely?

[evilengine#9 0]

If anyone can shed some light on this that would be great! I am looking to swap the cobra 5000's on my Graf Ultra G70's for LSP2's. The less holes i have to drill the better.

Thanks,

EE#9

[JR Boucicaut 3810]

Dixor - they came undrilled from Graf. The equipment manager mounted them with RMS himself.

Evil Engine - only two holes match - either the fronts or the back.

[evilengine#9 0]

Thanks JR,

Question for you then, if i am going to drill new holes, it is best to reuse the front or back or does it not make any difference?

Thanks,

EE#9

[JR Boucicaut 3810]

Do you know what you're doing? If so, you will figure out the ones that will work.

[evilengine#9 0]

Yeah, i worked in a store for a few years, just wondered if it made any difference now with the full composite soles.

Cheers

EE#9

[JR Boucicaut 3810]

Dixor - they came undrilled from Graf. The equipment manager mounted them with RMS himself.

Evil Engine - only two holes match - either the fronts or the back.