Custom+, LS, LS2 & LS2P

[Dubious 0]

there is no difference between custom + and tuuk + besides the name correct?

so you can use a custom+ runner on a tuuk+ holder

[JR Boucicaut 3795]

Yes

[sjf585 0]

4 and a half years later , but will the lightspeed 2 steel fit into any other holder??

[JR Boucicaut 3795]

Yes, the Lightspeed holder was always the same (except for the Lightspeed 2 Power holder, which was the translucent one)

[jazzyc4t 0]

Sorry for bringing an old post back to life... but I have Graf 703s with Tuuk Custom+ on them. If I get a pair of lightspeed (not lightspeed 2) holders, do I need to drill new holes again?

[Ankles 3]

If the shop you bring them to actually does the correct job, some of the holes will not line up exactly the same.

[greyskull 21]

Sorry for bringing an old post back to life... but I have Graf 703s with Tuuk Custom+ on them. If I get a pair of lightspeed (not lightspeed 2) holders, do I need to drill new holes again?

Yes you will, as JR said the back MIGHT line up, but the rest of em are miles out.

[jazzyc4t 0]

Thanks... i knew lightspeed 2 holders dont line up with custom+, just wanted to see if it was the same for lightspeed. Thanks!

[JR Boucicaut 3795]

Original LS? The only difference between it and LS2 is the slots on the side of the holder. Everything else is the same.

[jazzyc4t 0]

Thanks JR, I'm referring to the original LS. A buddy of mine had an extra pair in his basement and I was planning on taking them but if I need new holes in my boot I'm going to pass on them.