Graf RMS scews

[kasparaitis 0]

Anyone know the recommended torque for the graf rms scews? I don't want to over tighten these.

Thanks

[interpathway 9]

Anyone know the recommended torque for the graf rms scews? I don't want to over tighten these.

Thanks

ive always followed the recommended rule of thumb (learned from MSH), tighten until it sets, then back off a quarter turn. apparently it is a mess if you overtighten (or accidentally use the wrong type of locktite) and try to replaced your steel.

a good tighten and back off keep the steel in place, and just bring a flat head screwdriver in your bag, no big deal :)

[kasparaitis 0]

Thanks for the reply. That's what I'm currently doing. I was just curious if someone actually had a hard # on the recommended torque. what type locktite are you using? I've got some blue, but that's for high temps.

[JR Boucicaut 3810]

You want to use blue.