LetsGoWings13 0 Report post Posted August 30, 2004 ok i have a bauer 5000 helmet and i started rubbing the logos out with rubbing alcohol and all the logos did was fade is there any way i can get the faded letters out. Share this post Link to post Share on other sites
LetsGoWings13 0 Report post Posted August 30, 2004 no one knows Share this post Link to post Share on other sites
kosydar 0 Report post Posted August 30, 2004 Wait a little longer than 15 minutes for an answer, bud. Share this post Link to post Share on other sites
Ranger-#8 1 Report post Posted August 30, 2004 I used a pocket knife and used the tip to scrap the logos off. Share this post Link to post Share on other sites
Jbone 0 Report post Posted August 30, 2004 Electircal tape. Share this post Link to post Share on other sites
joshy207 15 Report post Posted August 31, 2004 Covering them with electrical or colored plastic hockey tape is probably the best way to go. Most of the liquids you can use to remove the logos could potentially weaken the helmet, and would most likely void the warranty. On the other hand, even putting tape on your helmet could void it too, the adhesives could affect the plastic.I'd recommend tape. Share this post Link to post Share on other sites
wristshot19 0 Report post Posted August 31, 2004 Mineral Spirits. Share this post Link to post Share on other sites
Kovy_Ribs_Fedo 3 Report post Posted August 31, 2004 You can use plastic spraypaint...It works for me. Share this post Link to post Share on other sites
wristshot19 0 Report post Posted August 31, 2004 Belt Sander. Share this post Link to post Share on other sites
joshy207 15 Report post Posted September 1, 2004 Belt Sander. I also hear you can lay the helmet down on its side and chop the front logo off with an axe... Share this post Link to post Share on other sites
