Making custom blade

[Furyan 1]

Hi folks

I've heard we could change face angle and curve of composite blades

Is it true?

All I've heard - I should just heat the blade by heatgun and than curve it

In addition, I found this link about stick curver

http://www.modsquadhockey.com/forums/index...mp;#entry617961

Somebody did something like that?

[Ogie Oglethorpe 14]

Lots have tried it. The stick curver, however, is intended for WOOD blades, not composites.

I have never heard anyone who tried to recurve a composite have major success as it causes a shorter life span of the blade (burns off some of the resin of the blade making it structurally less rigid as well as boils the foam out of the center of the blade as it's boiling point is lower than that of the composite, etc).