XN10 Pro Stock

[black296tuuk 3]

I pulled out a pro stock XN10 blade today. It was a Gleason pro stock but on the inside on the blade it was stamped "Modry". I thought it was pretty cool. I have pulled out a ton of pro stock blades like that before but I have never seen one stamped.

[jay 1]

My P31 was stamped Sundin FWIW.

[Eazy_b97 1]

How are you guys pulling these out? Just heating alot?

[clarkstowncaps15 0]

ya how are you guys pulling these out?

[kovalchuk71 212]

Sorry but was that really a necessary post clarkstowncaps??? Someone already asked ;)

EDIT: If he hadnt seen the post before him he wouldnt have said "ya, how do you"

I was just pointing it out.....

[IginlaIsABeAst12 0]

geez, give him a break, he must not have seen the post... ease up a littl ebit

[Eazy_b97 1]

geez, give him a break, he must not have seen the post... ease up a littl ebit

They weren't close and he did refer to my question, it just makes things a little easier when the thread flows a little easier.

[jay 1]

A lot of heating and pulling got the tenon out of my shaft. I also cut through the shaft all the way around just above the fuse point to try to help it release.

[black296tuuk 3]

I added pictures, you need to look really close to see the stamping.

[kovalchuk71 212]

that is a weird tennon :o

[Jbone 0]

Why did you cut the tenon of of the blade?

[black296tuuk 3]

if you drill down the shaft, it helps heat up the entire tennon

[Buzz_LightBeer 973]

i dont see "Modry" on that tenon anywhere, maybe my eyesights going in my old age :(

[black296tuuk 3]

I used paint to draw where it is in the other pictures