pulling the sicore blade out

[sweetblazer 0]

Hey,

I know there have been topics on pulling blades out in the past. I recently managed to jam the shaft of my sicore over the blade about a 1/4 inch. My question is can I pull the blade out of one of these easily? I've done it with 2 XX's and a response, I'm just wary of doing it with the sicore cause its by far my favorite stick of all time, But I also don't want to snap it at the blade and not be able to use the blade.

Any help is appreciated.

[Ogie Oglethorpe 14]

You can't PULL it out, but you can certainly convert it. You have to cut it and then use a combination of heat, flat head screw driver, and hammer to "chisel" the interior remnants of the old tenon.

Try some of these topics:

http://www.modsquadhockey.com/forums/index...?showtopic=7494

http://www.modsquadhockey.com/forums/index...showtopic=40797

http://www.modsquadhockey.com/forums/index...hl=cut++tapered

http://www.modsquadhockey.com/forums/index...showtopic=25739

http://www.modsquadhockey.com/forums/index...showtopic=19669

There are really no shortage of info on it.

Good luck!

[cptjeff 0]

The sicore works as a composite shaft if you can cut right above the old blade hosel. Should save you a little trouble.

And you won't be able to keep the blade. It's not like a warrior where you can just pull it apart as two separate pieces with no trouble.