Hockeyman9621 0 Report post Posted October 24, 2004 In an effort to make a Brett Hull like shaft. (I normally use 90-100 flex)I did the whole deal with drilling the hosel out and getting the full length of the shaft. So anyways, what size blade can I put in there? I'm not done filing the blade totally and was wondering if I can fit a sr. tapered blade? Thanks a lot for the help. Share this post Link to post Share on other sites
thejackal 46 Report post Posted October 24, 2004 You can't put anything in the plug end (too small for SR, too round for JR), and maybe a Jr tapered blade on the tapered end. Share this post Link to post Share on other sites
kovalchuk71 212 Report post Posted October 25, 2004 I fit a int. tapered in mine......but how low did you cut? I cut right in the middle of the "evil M" and it fit an int. blade perfectly... Share this post Link to post Share on other sites
Hockeyman9621 0 Report post Posted October 25, 2004 You can't put anything in the plug end (too small for SR, too round for JR), and maybe a Jr tapered blade on the tapered end. I can easily round a jr. ---Kovy, I cut it below that - right where the blade meets the shaft. Share this post Link to post Share on other sites
kovalchuk71 212 Report post Posted October 25, 2004 then a jr. may be better for you...but id seriously try an int.... Share this post Link to post Share on other sites
