Easton Razor Bladz

[silverjess 0]

I'm in desperate need of replacement runners for my Easton Ultra Lites 9D. (older models) One runner cracked near the mount screw. The local hockey shop couldn't loacate replacements saying the mount holes are too big for the new ones. Is there any hope for finding relacements??? Thanks for checking

[JR Boucicaut 3810]

No - at that point you are just better off swapping holders. Just put RBIIs on.

[silverjess 0]

I'm guessing the price will probably be more than new skates to replace them???

[JR Boucicaut 3810]

Probably $80 or so, up to you

[silverjess 0]

Ok thanks for the info!

[silverjess 0]

Ok, sorry to beat a dead horse to death, but if I were to find some runners and the holes were smaller than the originals, would I be able to drill bigger holes in the runners, or would it weaken the steel too much? Thanks again for the help.

[JR Boucicaut 3810]

I don't think you would have the tools to do it correctly, not to mention the connection points may be different.

[jimmy 194]

Ok, sorry to beat a dead horse to death, but if I were to find some runners and the holes were smaller than the originals, would I be able to drill bigger holes in the runners, or would it weaken the steel too much? Thanks again for the help.

yes, you can drill out the smaller holes in the late model easton steel and they will fit perfect in the old razors. Unless you have a drill press though and bits fro stainless, you won't be able to do it yourself. Many of my customers over the years have gone to their mechanic to have them drilled, with great success.