Jump to content
Slate Blackcurrant Watermelon Strawberry Orange Banana Apple Emerald Chocolate Marble
Slate Blackcurrant Watermelon Strawberry Orange Banana Apple Emerald Chocolate Marble

Archived

This topic is now archived and is closed to further replies.

ngray734

Graf Cobra to Tuuk Custom Plus sizing help

Recommended Posts

I have decided to change my Cobras to Custom Plus holders on my 8.5 wide 735's. My Cobra holder says 280 on it. Will the Tuuk Custom plus holder need to be a 280 also? Just want to know if they measure out the same. Figured some of you guys have done this before.

Share this post


Link to post
Share on other sites

Yeah, without actually looking, 8.5 wide should be 280.

You'll need to drill new holes for rivets and coppers that line up with the Tuuks though, the Graf RMS holes and anchors won't line up.

Share this post


Link to post
Share on other sites

There is actually a LHS, which has a great reputation in Metro Detroit, that only does sharpenings and skate repairs. They dont sell anything else besides a few insoles, laces, and tape. I'm surprized a place can stay open nowadays without offering more. Must be that good.

Share this post


Link to post
Share on other sites

There is actually a LHS, which has a great reputation in Metro Detroit, that only does sharpenings and skate repairs. They dont sell anything else besides a few insoles, laces, and tape. I'm surprized a place can stay open nowadays without offering more. Must be that good.

That's what they want you to think. I know the store in question and they're ok, but not "that good."

Just means he has lower overhead.

Share this post


Link to post
Share on other sites

I know a store not too far from you if you are willing to make the drive, prob an hour or so. It's off of M59. PM me and I will shoot you the info. Great LHS and always take care of everything I've needed. I drive over an hour just to go to them, even though I have a Perani's about 10 mins away.

Share this post


Link to post
Share on other sites

×
×
  • Create New...