stevelknievel 51 Report post Posted September 24, 2013 i just threw my visor back on my 4k helmet and noticed the dual density foam pads are a little dirty, whats the best way to clean them? i used a little soap and water but it didnt seem to make much of a difference. Share this post Link to post Share on other sites
romdj 26 Report post Posted September 24, 2013 Alcohol e.g isopropyl acetate should do the trick. Share this post Link to post Share on other sites
stevelknievel 51 Report post Posted September 24, 2013 I'll give it a shot thanks man Share this post Link to post Share on other sites
hunterphfr 12 Report post Posted September 26, 2013 A glue gun? Maybe it's the climate down here, but I'm pretty much over helmets with gel pads. Share this post Link to post Share on other sites
Chadd 916 Report post Posted September 26, 2013 The 4k is dual density VN, isn't it? I don't believe there are any gel pads. Share this post Link to post Share on other sites
stevelknievel 51 Report post Posted September 26, 2013 Maybe dual density isn't the right word its got the regular pads (think bauer 4500) Share this post Link to post Share on other sites
hunterphfr 12 Report post Posted September 26, 2013 The 4k is dual density VN, isn't it? I don't believe there are any gel pads.My bad. Share this post Link to post Share on other sites