Jump to content
Slate Blackcurrant Watermelon Strawberry Orange Banana Apple Emerald Chocolate Marble
Slate Blackcurrant Watermelon Strawberry Orange Banana Apple Emerald Chocolate Marble

Archived

This topic is now archived and is closed to further replies.

SCOMPL

Need help with shot

Recommended Posts

I have decent power behind my shot, but I've noticed that on long slapshots the puck tends to lean at a 45 degree angle en route to the net. Also, I struggle to "saucer" my snap shots and the puck tends to wobble. I feel as if something is wrong with my technique.

Could anyone please speculate what I might be doing wrong?

Share this post


Link to post
Share on other sites

Off the top of my head, you're probably not closing your blade enough. As for saucers, I find it really depends on your blade pattern but you generally want the puck to slide off the blade's flattest areas as much as possible to keep it flat.

Share this post


Link to post
Share on other sites

I might mention I've had the same problem using both a P88 (Kane) and W03 (Kopitar) curve. As far as closing my blade, do you mean I'm hitting the puck with the face of the blade too open? Or am I not turning my blade over enough in my follow through?

Share this post


Link to post
Share on other sites

Turn it over more on the follow through. Work on reaching and pointing in your follow through, make the full body commitment with it. You'll see a difference. The only downside is that a longer shooting motion takes a little bit more time.

Share this post


Link to post
Share on other sites

On your slap shot, I was taught that the puck leans because your blade is either:

- not square to the puck on contact

- not flat on the ice on contact with the puck ie either heel or toe heavy

- not hitting the puck in the center of the blade

Take your pick of any of those 3 or a combination, any will upset your slap shot.

Follow through is more about controlling the direction and elevation of the puck, if you have a look at a slow motion slap shot the puck is only in contact with the blade whilst the blade is in contact with the ice. As soon as the blade leaves the ice, the puck is leaving the blade. Assuming everything else about your slap shot is passable (technique, power, skating ability, stick flex etc) then the main damage to your slap shot is done when the blade hits the puck.

Share this post


Link to post
Share on other sites

The puck is tilting because the lie is off on your blade. The longer the shot, the more you will see it.

Share this post


Link to post
Share on other sites

The puck is tilting because the lie is off on your blade. The longer the shot, the more you will see it.

It may also be a rocker based issue if you recently changed blades. I've seen that a few times with myself.

Share this post


Link to post
Share on other sites

It may also be a rocker based issue if you recently changed blades. I've seen that a few times with myself.

Rocker isn't an issue if the middle of the blade is flat on the ice. If it isn't, I see that as an issue with the lie. A bigger rocker will make a lie problem more evident.

Share this post


Link to post
Share on other sites

I think you're right there but it's often hard to tell in many cases. By the way (to OP), anytime I've not skated or played in a while, my slappers are a little bit funky. I have to take a few minutes and slow down my shot motion. That usually solves it for me. Give it a go and let us know.

Share this post


Link to post
Share on other sites

×
×
  • Create New...