true1 question

[echi24 1]

well, the blade on my inno true1 has gone to hell, and im about to retire it, but i am wondering if it could be made into a shaft. I KNOW that it is a real one piece and there is no blade tenon in the shaft, but just out of curiousity can it be done and has anyone tried? i can see a little fuse line where the joined the blade and shaft is that where i should cut if i try?

[sherwood21 0]

If your going to retire it I would giver a go. I'm planning on trying to put a blade in one of my old Sherwood 7000's, that should be interesting.

[Fonya 0]

My dad had a prostock Roberts true 1 and he broke it and turned it into a tapered shaft.

[LkptTiger 1]

Worked for two of my old True-1s. The shafts didn't last very long afterwards, but it can be done...

Be prepared to chisel...and chisel...and chisel...

[flaming_june 2]

and sand, and sand, and file, and file some more....

[echi24 1]

can anyone post pics so i know where to cut? and by chisel you mean chisel the foam out so the blade tenon fits right?

wow the blade just gets wrose after every use, its at a point now where theres a giant creaking noise when i put pressure anywhere on the blade, i think its from the broken foam.