Furyan 1 Report post Posted May 7, 2021 hey guys due to my LHS doesn't have any skillful service men, i suppose they do profile like quad and zupperior for me with a mistake i mean they usually positioned pivot point at the center using quad template and just start profiling according to official Prosharp video (i put link below), i figure out that proper way is to move pivot point back to 20mm (as far as i understand) can anybody tell me which way is proper by default (as prosharp recommended) - to move pivot point back to 20mm or keep it in the geometrycal center? Quote Share this post Link to post Share on other sites
JV23 12 Report post Posted May 7, 2021 From what I can tell, if it is your first profile from fresh blades, centre is correct. If you are reprofiling a quad, you need to adjust for the fact that the template kicks the balance point 20mm, which is why they manually adjust. I am guessing here that is what you are asking because of the video you attached, which is only for a reprofile. Quote Share this post Link to post Share on other sites
