Drill size for holder rivets.

[Cyberoller 0]

I'm changing over holders but the holes will need redrilling. I want to make sure that the holder alignment is exactly how I want rather than a shop just fitting around the existing holes as I've seen happen. Could someone enlighten me as to the correct diameter hole for steel rivets and coppers. 

Thanks

[JR Boucicaut 3793]

5/32”. 

[Cyberoller 0]

Many thanks for the reply 5/32 is about what I'd guessed for steels, but the original CCM coppers I removed seemed a bit smaller, is there a standard drill size for them? 

[Bolgar 9]

Pretty sure no manufacturer uses different drills for copper rivers vs steel rivets. Coppers hold by their wide heads and washers, difference in fractions of millimeters is negligible 

[Cyberoller 0]

Thanks for the replies, I did think it was odd that the holes were different but rechecking the rear copper holes on the skates (CCM as1) don't seem to be big enough for a 5/32" drill bit, they seem to be 9/64".

I guess I could solve my own problem by just using steels 😉