true 1 blade conversion

[PuckHog 0]

i dont need to yet but i want to be prepaired to cut and fit a tapered blade into my true 1

if its possible can someone walk me through the steps to doing so with out loseing the length of my stick

[kovalchuk71 212]

Impossible.....your gonna loose quite a bit of length. Its a "true OPS", therefore these is no fuse point....Just flip it upside down if you want to save length

[Ogie Oglethorpe 14]

Impossible.....your gonna loose quite a bit of length. Its a "true OPS", therefore these is no fuse point....Just flip it upside down if you want to save length

I did it two of my Busch OPS - and they're true, one piece sticks.

It is a far greater pain in the a$$ than doing it with, say, a Synnergy or Response C8 I'll grant you, but can likely be done. I will note, however, the Busch shaft dimension caused my Busch shaft to take Jr. blades only (despite being a senior shaft).

[seanmccann 3]

The pictures below might help a little bit. A stealth turned into a shaft/blade combo.

http://www.msnusers.com/HockeyGearPictures...Photo&PhotoID=1

http://www.msnusers.com/HockeyGearPictures...Photo&PhotoID=2

[flaming_june 2]

http://www.modsquadhockey.com/index.php?sh...=1616&hl=true+1

[Eazy_b97 1]

The pictures below might help a little bit. A stealth turned into a shaft/blade combo.

http://www.msnusers.com/HockeyGearPictures...Photo&PhotoID=1

http://www.msnusers.com/HockeyGearPictures...Photo&PhotoID=2

The Stealth isn't a true one-piece though.

Ogie, I had a friend who cut a broken blade off of his Busch stick and had the same difficulties (only jr blades would fit). I broke mine in the shaft, so I didn't have to go through that.