LetsGoWings13 0 Report post Posted June 14, 2004 ok i am trying to break in my vectors. I got them baked and i used the ccm fit system on the skates and when i went to skate in them they hurt bad is there any other way to speed up the break in process. Share this post Link to post Share on other sites
PH_Hockey2 4 Report post Posted June 14, 2004 Lace them up at your house and walk around in them Share this post Link to post Share on other sites
Chadd 916 Report post Posted June 14, 2004 put on wet socks and wear your skates. Share this post Link to post Share on other sites
LetsGoWings13 0 Report post Posted June 14, 2004 thanks everyone for your suggestions. Share this post Link to post Share on other sites
stevo 0 Report post Posted June 14, 2004 Go public skating. I found the best way to break in skates was to actually skate in them as much as possible. It's only uncomfortable for the first few skates. Share this post Link to post Share on other sites
Justin 1933 134 Report post Posted June 17, 2004 You can probably re heat fit them. This usually helps....I know sometimes I have heated a skate twice.... Share this post Link to post Share on other sites
Lucius 0 Report post Posted June 17, 2004 Call me crazy, but I've always felt that even the stiffest skates shouldn't give you more than mild discomfort at first - unless, of course, they're the wrong shape for your foot. Share this post Link to post Share on other sites
wristshot19 0 Report post Posted June 17, 2004 You also might want to try different ways of lacing them up. Having skates too tight in the wrong spots can cause quite a few aches and pains. Share this post Link to post Share on other sites
asdfa 0 Report post Posted June 17, 2004 it would help if you told everyone where your foot hurts. when i first got my skates, they hurt like crazy, but that was only because i tied the midfoot way too tight Share this post Link to post Share on other sites
