LS 2 Power

[Cannon12 0]

Anyone else break one of these holders yet?

[pat19 0]

yeah i did last night, right where the holes above the steel are cracked. i didn't even know it until i got home. i just got them last week too.

[Cannon12 0]

Ya, 1 game and 2 practices on my son's. It cracked at the back right where the bolt is for the steel.

[mew1838 0]

Tell me which holders don't break?

[trevor13478 1]

all of the ones ive used on every skate ive ever had

[DamnLocust 0]

all of the ones ive used on every skate ive ever had

Just because YOU haven't broken a holder doesn't mean it doesn't happen. It just means you don't block shots, or you've been lucky.

[Cannon12 0]

Just for your info, the guy at the LHS said that they are breaking faster that they can be replaced on the shelf. Didn't have the right size so they put white Lightspeed's insted.

[DarkStar50 680]

Just for your info, the guy at the LHS said that they are breaking faster that they can be replaced on the shelf. Didn't have the right size so they put white Lightspeed's insted.

We have sold plenty of ONE90s. The only holder that cracked was an interior fracture on mine. I have plenty of inventory in holders and steel thinking breakage might be an issue. So far, it hasn't happened here. Where is your LHS?

[Jbone 0]

The Blades in mine come loose all the time. I'll tighten it and 10 minutes later it's loose again. They also make a loud cracking noise when I walk with them on.

[hockeypunk3 0]

Jbone

Use a little bit of blue locktite

Or get them checked at your LHS for damage.

[DamnLocust 0]

If the steel clicks in the holders and come loose often, Remove the blade, put some tape on the sharkfin, and reinstall. It's come up numerous times before.

I have a crackling noise when I walk on my L7s, but that's because of the holder flexing and the cheap rivets Mission used to install them. This may also be an issue you're experiencing, but the LS2P is supposed to be a stiffer holder than others.

[jimmy 194]

I haven't seen any broken holders at all. Lots of broken steel though. Of the 15 or more broken runners, about 5 broke where the bolt attaches, not on the runner.

[Jbone 0]

I've went to an LHS and got them tighten (I had to get holes drilled in the boot) and they still come loose. One of the guys said it might be the Lexon material rubbing against the bottom of my boot that's casuing the noises.

[Cannon12 0]

Small town Saskatchewan, Regina to be exact. One side was a huge crack and the other side was an internal crack. The other skate was an internal crack as well.

[tguidon 0]

The Blades in mine come loose all the time. I'll tighten it and 10 minutes later it's loose again. They also make a loud cracking noise when I walk with them on.

If the steel clicks in the holders and come loose often, Remove the blade, put some tape on the sharkfin, and reinstall. It's come up numerous times before.

I have a crackling noise when I walk on my L7s, but that's because of the holder flexing and the cheap rivets Mission used to install them. This may also be an issue you're experiencing, but the LS2P is supposed to be a stiffer holder than others.

Mine also click and they are on my Supreme 70's. Is it easy to take the blade out or should I go to the pro shop to fix this?

[DamnLocust 0]

there's a small hole in the bottom of the boot where you can loosen/tighten the bolt. It's easy, but if you don't have the tools or don't trust yourself with it, the shop shouldn't charge much to do it.