Vapor XXXX broken OPS to shaft

[ndlancer95 0]

I have a xxxx stick um. Where on the shaft do i need to cut to fit a blde in there, and will it be a tapered or standard blade? Thanks in advance

[Buzz_LightBeer 977]

wont work for a tapered, the inner dimensions are not conducive to inserting tapered blades, with out a lot of fooling around

[ndlancer95 0]

wont work for a tapered, the inner dimensions are not conducive to inserting tapered blades, with out a lot of fooling around

okay, so it will be a standard shaft. how high on the shaft will I have to cut , the blade was te original casualty

[Buzz_LightBeer 977]

very high, almost 1/3 the way up, forgive the expression but it would be a real F***story, i've tried it

[ndlancer95 0]

very high, almost 1/3 the way up, forgive the expression but it would be a real F***story, i've tried it

ok, thanks. I guess I need to pick up a blade annd a hell of a long plug, as even a bauer senior is normally short for me before cutting

[fatwabbit 93]

PM=ed you... might have a solution.

[yrhmblnr8r 69]

I've got a XXX that I cut to fit a Harrow tapered blade. Buzz is right that you'll have to take off a lot of length but it can be done.

Everything you need to know is probably covered here: http://www.modsquadhockey.com/forums/index...7494&st=315

[jrhky36 1]

i have one of lebda's xxxx that i turned into a shaft. i use a short hosel std blade in it. i cut it at 12 1/4" below the swoosh and it worked for me.

[ndlancer95 0]

Thanks guy witht he really long name, lol. I have to think. I'll get back to wabbit about those blades