Graf cobra tuuks on other skates like Bauer reebok Etc is it possible

[Hounds96 0]

Can you put Graf tuuks ultra 5000's on a reebok 20k skate or total one NXG Or do you have to have a indrilled factory boot to make new rivet holes

[strosedefence34 179]

yes you can. What you are referring too are the Cobra holders made by Gref. Tuuks are the holders made by Bauer. As for drilling additional holes into the new boots that all depends on if the holes from the old holders line up with the holes from the cobra holder. Just bring them to a LHS that you trust will do a good job of mounting them and you should have no issues.

[Hounds96 0]

Yes I am meaning to say can you put a cobra 5000 holder on a reebok 20k skate with out having to have an undrilled factory boot and vice versa can you do the same with a tuuk custom + on a graf g75

[cooperalls 4]

Yes I am meaning to say can you put a cobra 5000 holder on a reebok 20k skate with out having to have an undrilled factory boot and vice versa can you do the same with a tuuk custom + on a graf g75

Yes, both of those combinations are possible, without undrilled boots.

[laserrobottime 149]

Bringing this thread back to life:

I have a pair of pro spec Bauer Nexus 1000 boots that are very comfortable, and some Graf cobra 5000 holders with profiled step steel. I love the pitch of the cobras and the shape of the runners.

1) If I were to swap the LS 2s off of my Nexus boot, should I have the shop drill extra holes through the 5000 holders for additional rivets? The RMS mounting has only 8 holes through the holder.

2) Will the heel and toe of the holder line up adequately with the boot outsole? Or am I asking for trouble here?

Looking for specific advice from people who have made this swap before.

Thanks!