shoot_the_goalie 285 Report post Posted February 4, 2020 Seems like the screw bolt on the steel would make this problematic? Or can the bolt be taken off easily? Share this post Link to post Share on other sites
VegasHockey 1284 Report post Posted February 4, 2020 53 minutes ago, shoot_the_goalie said: Seems like the screw bolt on the steel would make this problematic? Or can the bolt be taken off easily? Bolt comes out easy. I use a small press to pop it out but you can also do it with a rubber mallet and a screw driver. Just give it a swift tap and it pops right out. Share this post Link to post Share on other sites
shoot_the_goalie 285 Report post Posted February 4, 2020 (edited) So you're saying to tap this part out? (marked in red) https://imgur.com/M2r0rEB Edited February 4, 2020 by shoot_the_goalie Share this post Link to post Share on other sites
JR Boucicaut 3816 Report post Posted February 4, 2020 But you don’t have to take out the bolt. It’s not interfering with anything. Share this post Link to post Share on other sites
shoot_the_goalie 285 Report post Posted February 5, 2020 2 hours ago, JR Boucicaut said: But you don’t have to take out the bolt. It’s not interfering with anything. Sorry, Should have probably been more clear. I'm trying to use the True 1st gen Step steel with my Sparx using the Sparx blade holder. Am I missing something, because I can't see how to get the steel to seat into the holder if the bolt is in place? I can see how, if it was in say a Tri-Lie holder, it wouldn't be an issue... but not sure how to get it to work with the Sparx holder. Share this post Link to post Share on other sites
IPv6Freely 2100 Report post Posted February 5, 2020 Just take the bolt out then. Share this post Link to post Share on other sites
