noupf 43 Report post Posted May 22 (edited) I've got a pair of 100k pro's that I love. Plenty of life left in them. As many know, the inside of the toe cap area on those and some other recent CCM skates has a bit of a bump out on the inside. Only bothers me occasionally. But I am curious if anybody knows if using a device like this ( its marketed as a boot punch for ski boots ) on the circled area could help punch it out some? I'd assume a little heat and maybe some light pressure sitting overnight should make it happen, but i dont want to destroy anything incase i'm wrong. Thoughts? Thanks !! Edited May 22 by noupf Share this post Link to post Share on other sites
TheWontonDon24 1 Report post Posted May 23 I would think a pro shop could punch them out in that area. Share this post Link to post Share on other sites
swede 58 Report post Posted May 23 Yes, you can use a ski boot punch to punch out small pressure points, but you rather buy one with longer handles to get better leverage. The club i coach for has one, and iv’e used it a couple of times to punch out the toe caps on my Vapor 3x in the same place that the ribcors give you problems. It works great, but you need to heat up the plastic to the point that it gets moldable but still being careful not to melt the plastic. Share this post Link to post Share on other sites
shoot_the_goalie 294 Report post Posted May 24 That's a tough area to punch out, but it's doable. Main thing is that it will require discipline and patience, cause it's gonna take a few careful cycles to get that area punched out properly without damaging the skate. Maybe one day, skate manufacturers will start creating a "pinky toe" zone like they do with ski boots, where that part of the boot is semi-flexible to accommodate for bigger pinky toes. Share this post Link to post Share on other sites
beerleaguecaptain 1007 Report post Posted August 10 we wont punch a toe cap. How did it work for you? Share this post Link to post Share on other sites