Jump to content
Slate Blackcurrant Watermelon Strawberry Orange Banana Apple Emerald Chocolate Marble
Slate Blackcurrant Watermelon Strawberry Orange Banana Apple Emerald Chocolate Marble

Knights15

Members
 View Profile  See their activity

  • Content Count

    21

  • Joined

  • Last visited

  • Feedback

    0%

Trader Feedback

0 0 0

View Feedback

Community Reputation

3 Neutral

Profile Information

  • Spambot control
    123456789
  1. Knights15
    Bauer x7.0, labeda grippers, mission hi Lo. These are the same skates from my last post, got them redone and mounted further back. These are my old ice skates and they fit perfectly, so it's great I could convert them and continue using them.
  2. Knights15
    It's the correct size chassis, but I'm getting them remounted further back.
  3. Knights15
    Bauer x7.0, mission chassis, labeda gripper wheels. After much deliberation over whether to do them myself, I sent these off to a proshop to do them. Unfortunately when I received them back the job was done poorly. Sent them back to be repaired, and a good job done. Only issue is how far forward they have been mounted. Has anyone skated on similar and how is it? For me it feels strange and not sure if I could get used to it.
  4. Knights15
    Is your chassis mounted on the indent?
  5. Knights15
    So having inspected my x7.0 outsole before fitting the chassis. The outer part of the outsole is significantly thicker than the the middle, where there is like a channel, where it is very thin. Problem is, a couple of the mounting holes would be on this thinner part. Will it still be strong enough to hold up?
  6. Knights15
    Just about to start my project, quick question, do vapor boots have any give in them? My chassis doesn't sit flush along the bottom and there is a gap, I take it it would pull together to meet the mounting plates?
  7. Knights15
    Cool can you tell me what I will need?
  8. Knights15
    Looking to mount a hummer on my ice skates. Problem is in the UK I can't see tnuts anywhere online, and I'm also unsure of what material to make shims out of to create the clearance required. Can anyone guide me in the right direction?
×
×
  • Create New...