snipez96

I think it's worth the gamble if you can get them at a decent price. I took the gamble and no "bumps" here. I'm curious to hear what socks people are using. The bumps are coming from friction. One would think using a good quality sock that comes up high enough could alleviate the issue. I'm using the bauer elite performance sock which could be the reason that I don't get the bumps

Went in to my LHS this afternoon picked up a pair of One.9 skates I figured what the heck 40% off can't go wrong

If you look at ms. Knight's Instagram she Also has mako bumps from her Mako 1

Thanks guys after the last two posts I'll probably just stick to the CXN and try different profiles and pitches. Worst case get new steel and go back to stock

Is there any updates from anyone switching from CXN to Tuuk Edge holders?

I'd give them a call they'll hold them for you

Did you try Crows in Oshawa?

Picked up a Bauer HS23 $40 not a bad pick up

Still using stock runner/holder Had a bit of knee strain for the first two weeks on my left side. Then again I've had problems with it before my makos. No problem now it has adjusted to the pitch

I came from vapor x100 with the same issue...shouldn't be a problem

I actually just left my LHS to get that done. They used a heat gun and pinched the the boot just above the heel below the ankle area. Hopefully it dose the trick. I'll let you know tomorrow if it worked

Helmet - Easton E700 Visor - Bauer HS23 Shoulders - Bauer One80 Elbows - Bauer 6000 Gloves - Easton Mako M5/Bauer APX Pants - Bauer Supreme One80 Shin Pads - Bauer Nexus 1000 Skates - Bauer APX2 Twigs - Easton V9E E28, Bauer Apx P92 lie6

Well Christmas came early found a pair of Makos in my size wife agreed to pay for half...whooooo! I couldn't resist my LHS had V9's on for 20%off had to try the E28 pattern loving it so far

Updated below

Well the I got to try the makos today had them baked it's amazing how much width and depth you gain after baking. I tried them on last week left skate felt fine out of box right needed baking. Unfortunately after baking the area where the tendon guard and skate meet was pinching my leg the shop tried opening up that area just couldn't get it right. I tried on a half size larger no problem at all with pinching but the boot had too much volume I wasn't even grazing the end of the toe box. It's too bad would have been a perfect fit throughout. The boot really wraps around my foot well. Hopefully the next gen model will work for me. So till then I'm in x100s :(