GTHL_AAA_HOCKEY 0 Report post Posted June 6, 2004 Where do I have to cut on a Vapor XX intermediate ops to insert a tapered blade? Share this post Link to post Share on other sites
kovalchuk71 212 Report post Posted June 6, 2004 have u tried heating the shaft up and taking the blade out? Share this post Link to post Share on other sites
GTHL_AAA_HOCKEY 0 Report post Posted June 6, 2004 oh, so is that what you do? You dont cut it? Share this post Link to post Share on other sites
kovalchuk71 212 Report post Posted June 6, 2004 u dont have to, with some u can just heat the shaft and take the blade out. i did it with my GI Petrovicky one and others have done it on here too. just give it a try and pull hard. use a vice or something to hold it. :) Share this post Link to post Share on other sites
GTHL_AAA_HOCKEY 0 Report post Posted June 6, 2004 ok, thx, ill try that. If it doesnt work (maybe because it is not GI) does anyone know where to cut it; and save the taper? Share this post Link to post Share on other sites
kovalchuk71 212 Report post Posted June 6, 2004 if heating it dosent work, cut at the fuse point and chisel out the rest. Share this post Link to post Share on other sites
Cavs019 702 Report post Posted June 6, 2004 Are the intermediates the same dimensions as the senior with just a softer flex? Share this post Link to post Share on other sites
JR Boucicaut 3760 Report post Posted June 7, 2004 No.LOL however if you're interested in one, I'm selling one, brand new, choice of hand/curve. Share this post Link to post Share on other sites
kovalchuk71 212 Report post Posted June 7, 2004 isnt that supposed to go in the sell forum JR? ^_^ :D Share this post Link to post Share on other sites
