Leaderboard

Another glove find, NEW unused Torspo gloves. Very nice gloves, low cuff.

Same as the old Tacklas, as far as I can tell. I'm 6'1 and somewhere between 32"-34" inch waist, and the large fits me well

It's mostly a formality to keep the trademarks, same story as why Bauer chucks something with the Easton logo out there every now and then :/

Let's see a pic of the current state of these, because DIY gear mods are great

I haven’t been active much lately with recovery from a broken knee, and lack of ice times. I was the same, blowing good money after bad on shoulders that didn’t fit right. Before I got hurt, stopped wearing my shoulders, a pair of older Supreme TotalOnes, and started wearing a padded shirt that I made. Which was fine, until some plug who I play with and can’t aim took a shot during warm ups and bounced it off my shoulder. I put my TOnes on, and remembered how bulky they were. I went back to the grind stone ,and saw an archived post here and then it dawned on me: I had always assumed removing the caps meant the whole piece, and never considered removing the hard shells from the foam. Fast forward, a couple hours of seam ripping, and getting some donor material from a pair of older X800 SMU shoulders (mostly for the Velcro and an extra foam pad), and here’s what I have. I restrung the shells with some 10lb test fishing line and glued some Velcro on the back side for when I need the hard shells, which is rarely. The black vapor foam is if I need extra padding without needing the shells. Otherwise, just rocking the TOne foam with the bicep guards.

RIP 😧