ironslave 2 Report post Posted June 6 Anyone try these yet? Seems like the pitch is more neutral compared to past holders. Also seems lighter. How does stiffness compare? Quote Share this post Link to post Share on other sites
A2rhino 79 Report post Posted June 10 Scott Says that this is now a more neutral pitch in the video about the new skate attached. Quote Share this post Link to post Share on other sites
flip12 729 Report post Posted June 11 I haven't seen it in person, but I'm impressed with the direction their design is going. Both for the holder and the boot. The Shift holders looked way too busy. Quote Share this post Link to post Share on other sites
A2rhino 79 Report post Posted June 12 It grows on me a bit more each day. 1 Quote Share this post Link to post Share on other sites
mcne0101 17 Report post Posted June 17 They look promising but where can you buy steel to fit these? I don't even see any on the True website... Quote Share this post Link to post Share on other sites
A2rhino 79 Report post Posted June 18 (edited) I reached out and they said you can order it directly from them right now. Just need to call or email them. I'm not steel specialist but from the video I posted above this steel design sounds very interesting. Edited June 18 by A2rhino 1 Quote Share this post Link to post Share on other sites
A2rhino 79 Report post Posted Thursday at 03:52 PM (edited) Per the team at TRUE In CAD, plus shipping: SpeedShift HP DLC Steel is $199.99/pair SpeedShift Holder is $69.99/piece(not pair) What are the chances of this steel bowing and holding up to a heavier person with the cutouts in them. I remember when Bauer did this and it was a disaster. Edited Thursday at 03:57 PM by A2rhino Quote Share this post Link to post Share on other sites
Sniper9 551 Report post Posted Friday at 04:30 PM On 8/7/2025 at 8:52 AM, A2rhino said: Per the team at TRUE In CAD, plus shipping: SpeedShift HP DLC Steel is $199.99/pair SpeedShift Holder is $69.99/piece(not pair) What are the chances of this steel bowing and holding up to a heavier person with the cutouts in them. I remember when Bauer did this and it was a disaster. The cutouts in these is minimal compared to what Bauer tried on a couple of occasions with the triangles on the vapor 8? And also the slots on the one90? Also Bauer steel is/was not great particularly back then. 1 Quote Share this post Link to post Share on other sites
A2rhino 79 Report post Posted Friday at 05:45 PM Good to know. I just ordered the new holders and steel. Look forward to taking them for a test drive. Will place a photo when they have been installed. 1 Quote Share this post Link to post Share on other sites
