Leaderboard

Guys. You were totally right about sizing issue. Went to a different local hockey store at lunch time. spoke with the guy over there. Looked very knowledgeable and asked me lots of questions about my issues with the Ribcors 9.5D. He measured my foot and quickly said: Mister customer, you need to go down to size 9 or maybe 8.5. Mister customer, you got a narrower foot than average. Mister customer: you got to feel lost with the 9.5 ribcors and skate like an a$$. We tried different brands in the mid range level $500-700$cad (I dont want to spend $1200 and I only play once a week). True were no bueno for me. Awkward fit inside. Too much padding in some spots and not enough elsewhere. CCM JetSpeed - in the mid range they don't offer tappered fit on jetspeed so overall size 9 regular width felt ok not good. Room for improvement. Bauer Supreme Matrix (Similar to M5) - size 9 fit 1. Was comfy in it. But ankle felt unstable and balance point was hard to reach. Vapor X4. size 9 fit 1.Wow! I think we got a winner. Foot felt wrapped and supported. No dead spot inside the boot. Toe were brushing end of toe cap. Also tried size 8.5 fit 2 (they didnt have fit 1 size 8.5 in stock). Length wise, with the 8.5, it felt a bit tight and toes were slightly bending/curving. Even with knee in flexion. Not sure if this will be good or not. Bummer they didnt have the 8.5 fit 1 in stock. The guy at store told me: 8.5 is the fit I'd suggest if looking for a more "pro fit". Size 9 is "comfy performance fit" I didn't pull the trigger. Was in a hurry at lunch time and didn't want to take a decision too quickly. But will look to try size 8.5 fit 1 in the vapors.

From what I’ve seen, most boots run the quarter material all the way to the end of the facing. It makes sense because that area experiences a lot of force, so it’s usually reinforced with some pleather and the grommets to ensure some longevity. How thick the shell materials are through the facing, I’m not sure. If they stopped the quarter material and stiched pleather to that borderline all along the edge to make a kind of facing extension it would probably be a weak connection and prone to failure.