I finally got to try my new Mako 2 skates out twice so far. Once on Sunday in a game and it didn't go so well. There was a problem with the sharpening, the edges on both skates were uneven. So I couldn't skate properly and felt unsure on my feet. On a good note I never had a problem adjusting to the pitch of them as I'm coming from Graf 707's. I got size 10.5EE and the sizing was perfect. The skates did feel comfortable except for after the game I noticed I had 2 cuts or scrapes on my left ankle, one on the outside and the other in the front where your tongue sits. So this isn't good as I remember people complaining about getting them with the original Makos. After getting my skates resharpen and fixing the edge problem I had my 2nd skate on Tuesday and it was just pickup. I noticed right away skating around in warm-up that my skates felt normal like my old ones and I could turn without problems. So I felt really confident on them the whole time I was skating. I did find that I was a little quicker out there then my old skates cause maybe of the more forward pitch, but like I said I should be used to it coming from the Grafs. I'm not sure about the skate liner as I wear barefeet and my feet sweat a lot so I think this could be a slippage problem. I might have to start wearing a thin skate sock to help with this. I also noticed my top of the ankles were hurting a bit when turning from the side of the skates digging into them. I like to have my top few eyelets nice and tight so this could be causing this. I also noticed some more small scraps or cuts on my right ankle this time that didnt happened after the first skate. Now I have them on both ankles which I'm not happy about. I put bandages on my left ankle before playing but that really didn't help much. I'm thinking about buying some sleeves to wear around my ankles so any suggestions would be helpful. I was going to try some Tensor sleeves I have first, but they are kinda thick so I don't think this is going to be a solution. However I still do like the skate so far but obviously don't like having cuts on my ankles. If this goes away after getting them properly worked in then no biggee. Yes I got them heated up at the store where I bought them. Just thinking now that this shouldn't be happening as I thought Easton fixed these problems. I was going to buy them for my daughter in the fall, so hopefully these problems can work themselves out.