Leaderboard

Here's a good pic on my FB page https://www.facebook.com/LaSalleSkateShop

Or you could get yourself a speedy stitcher and mod it a little. In the past I've added the spine protection from an old pair of shoulder pads to a TotalONE girdle, you could do something similar here without having to spend money for another girdle (especially since the ST has also been discontinued and there now is the JetSpeed) 🙂

no not at all. I've been a speedplate guy generally and like the stiff feeling under my feet, but these are not 'squishy' at all. The red piece is very thin and not really anything special.

Are they; A- trying to use the same holes without drilling new? B- trying to install the holders with steel taken out? That would be the most likely culprit imo. when I swap holders, I mark the center of where I want the holder front and back. I use 2 strips of 3M thick double sided tape to hold the holder in place so I can readjust. The tape holds the chassis in place while you drill a stabilizing hole front and back. That should get the holder attached straight and square for finishing drilling. If for some reason the bottom of the boot and top of the holder aren’t square a small shim may take up the needed space

Problem is who what team and player they used to show off the inclusive and non-misogynistic bullshit...