Slate
Blackcurrant
Watermelon
Strawberry
Orange
Banana
Apple
Emerald
Chocolate
Marble
Slate
Blackcurrant
Watermelon
Strawberry
Orange
Banana
Apple
Emerald
Chocolate
Marble
Doughnuts08
-
Content Count
68 -
Joined
-
Last visited
-
Feedback
0%
Recent Profile Visitors
3182 profile views
-
Kings, Sharks, and Bruins interested so far from what I've heard
-
Hmm, not sure about that one
-
I use a quad done by a Pro Sharp machine
-
I'm running a quad .5 on 263s right now which I like...I'm switching to a 271 though on my new skate so am going to go up to a quad 1
-
^ they have non colored blades FYI
-
If you look at the sticker on the top of the stick, HSMTSM will be a mid kick point, HSMTSV will be a low kick point
-
I have a set on my FT1s right now with a quad .5 profile....noticeable improvement from my stock SB hyperglide steel....more ice surface contact, more height to the steel, and the edge has held alot longer so far
-
M means the plant it was made in (Mexico) and the T is the shape of the shaft. T is traditional (square shaft)
-
Is that Nick Cage on your sweater? lol
-
The 70k is a little cheaper You can still get any of the skates in diff widths, but the skate design will play into the fit also. A Jetspeed D width will be a narrower fit than a Tacks D width
-
The overall design of the skate is the same so a jet speed will still fit a narrow foot better than a tack. However on the total custom you can change the stiffness all across the boot to get it as stiff as the tacks or even stiffer
-
Full custom for FT1, AS1, and 70k, Pro custom which is just the mold only is for only AS1 -
The scanner will cost 4000 - 6500 for the shop to get from CCM
-
The orthobed or just those custom arch supports for low, medium, high?
-
So here's my impression of this problem after getting my feet scanned. I currently wear a 7.5D Jetspeed FT1 retail...after getting my foot scanned, the system recommended a size 8D RibCor or 8D Jetspeed. However if you look at the 2nd page of the scan, which measures your foot in CM, it showed my left foot at 26.5 CM (size 7.5) , and my right foot at 26.9 CM (size 8) So I think for the recommendation they go off of the bigger foot so as not to have one foot smashed, since the pro custom (which shapes your mold around a retail boot) will have both feet the same size. If you go full custom it allows you to get a different length size for each boot in which case CCM will use the actual CM measurements of each foot
